You are here: 2012

Loxo.vn

Tiếng Việt (Vietnamese)English (United Kingdom)简体中文
JA slide show
Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

Conical Compression Spring

Parameters of conical compression springs
Physical parameters

  • d (wire diameter): This parameter describes the diameter of wire used as material for spring.
  • S (shaft): This parameter describes the maximum diameter of spring shaft in industrial applications. Tolerance for this parameter is (+-)2%(indicative).
  • De (Larger External Diameter): External diameter at large end of the spring. Tolerance for this parameter is (+-)2%(indicative).
  • Ds (Smaller Internal Diameter): Internal diameter at small end of the spring. Tolerance for this parameter is (+-)2%(indicative)
  • H (hole): This is the minimum diameter of the hole in which spring can work. Tolerance for this parameter is (+-)2%(indicative).
  • Ln (Block): Maximal length of a spring after total blocking. For most conical springs this value equals double wire diameter. Tolerance for this parameter is (+-)2%(indicative).
  • L0 (free length): Free length of compression springs is measured in its uncompressed state after previous one time blocking. Tolerance for this parameter is (+-)2%(indicative).
  • R (spring rate): This parameter determines spring's resistance, while it is working. It is measured in 1 DaN/mm = 10 N/mm. Tolerance for this parameter is (+-)15%(indicative).
  • L1 & F1 (length at force F): Force F1 at length L1 can be calculated from equation : F1 = (L0-L1) * R. Equation derrived from previous for calculating L1 : L1 = L0 - F1/R.

Materials

  • I (Inox steel): Inox 18/8 mark Z10 CN 18.09.



  • «« Start
  • « Prev
  • 1
  • Next »
  • End »»
Results 1 - 5 of 5

Hỗ trợ trực tuyến

TP Hồ Chí Minh Hà Nội
(A.Nghĩa) : 0366.888.919
Zalo : 0366.888.919
Torsion
Torsion
Lò xo 4
Lò xo 4
Lò xo 19
Lò xo 19
Torsion 5
Torsion 5
Spring 4
Spring 4